How To Unscrew The Nozzle Of A Perfume Bottle

Dec 04, 2025

Leave a message

The most recommended method is to unscrew the outer cover first, then use scissors to clamp the nozzle base diagonally, and slowly pull it out to avoid vertical hard pulling that may cause the glass bottle to break or the nozzle to be damaged. If the nozzle is tight, you can use tools to assist in disassembly. The following is a specific operation guide:

 

1. Basic disassembly steps (applicable to most standard spray perfumes)
Remove the outer cover
Hold the bottom of the bottle with one hand and turn the outer cap counterclockwise with the other hand to remove it. When some bottle caps are tight, paper towels can be used to increase friction to assist in unscrewing them.

Determine the nozzle structure

If the nozzle is detachable (common in mid- to high-end brands), it can be pulled out directly by hand or tool.
If the nozzle and bottle mouth are welded and fixed (such as some luxury brands), destructive disassembly is required.
Use scissors to pull out the nozzle diagonally
Use kitchen scissors or ordinary scissors, clamp the metal base of the nozzle with the cutting edge, apply force diagonally upward, and use the lever principle to gradually loosen the nozzle. Do not pull it out vertically to avoid scratching your hands or damaging the bottle mouth.

 

2. Advanced tool method (applicable to stubborn nozzles)
When it cannot be disassembled manually, you can try the following methods:

Pliers method‌: Clamp the nozzle neck guard with needle-nosed pliers, shake it gently left and right to loosen it, and then pull it out. Be careful to keep the pliers perpendicular to the bottle body to avoid concentrating pressure on the neck of the glass and causing it to break.
Scissor cutting assist‌: Use scissors to cut back and forth around the edge of the nozzle to weaken the fixing force of the metal hoop, then use the tip of the scissors to pry the gap and gradually separate the nozzle.
Utility knife + screwdriver combination‌: Use a utility knife to pry open a small opening in the gap between the edges, then insert a flat-head screwdriver to expand the gap, and finally use pliers to pull it out.


3. Precautions and risk avoidance
Safety first‌: It is recommended to wear gloves and goggles during operation to prevent glass from breaking or tools from slipping and injuring hands.
Protect the bottle: Avoid using brute force, especially for narrow-necked glass bottles. Excessive pressure can easily cause the bottle to burst.
Follow-up treatment‌: After removing the nozzle, if you need to repackage the perfume, you can use a special dispensing funnel or pour the liquid directly into a vial; if the original nozzle is damaged, you can purchase a universal replacement pump head for installation.


4. Suggestions for handling special types
Nozzle with outer cover: First cut off the plastic layer of the outer cover, and then disassemble the internal metal nozzle.
Aluminum sealed nozzle‌: Some perfumes use aluminum ring laser welding technology, which cannot be disassembled without damage and can only be opened by cutting or destructive means.
Old-fashioned intubation perfume: No nozzle design, just pull out the rubber stopper and glass tube by hand.

Send Inquiry